RS1500 - Temperature Controller

• Economical entry level variants
• Full-value regulation and control

Basic functions:

• 3-point controller, PID controller, heating and cooling switching hysteresis
• Control functions with inputs and outputs or for temperature control solutions
• Front installation, optional: Installation from the rear

Operation:

• 7-segment display, 2 rows
• 4 keys
• 5 LEDs for alarms and further function displays

Control:

• PID control behaviour. The control behaviour can be adjusted via the feedback parameters.
• Setting the rate time, reset time (P,I,PI,PD,PID)
• Setpoint limit
• Self-optimising for adaptation to the controlled system
  • Self-optimising at start up and up to the setpoint.
  • The algorithm determines the characteristics of the system in a closed control loop and calculates the control parameters (Xp, Tv, Tn) over a wide range and the switching cycle time (C = 0.3 x Tv) of a PD/I controller.
  • After calculation of the feedback parameters, the controller returns the actual value to the current setpoint.
  • Self-optimising stopped: by alarm warning and switching off the controller
    Output ratio limitation
• The output ratio is output to the digital outputs in the form of a PWM signal.
  • The total duration of an On/Off cycle is determined via the switching cycle time parameter.
  • The value parameters are set separately for heating and cooling (P: switching cycle time heating or cooling).
  • Output ratio limitation is only needed in the event of fixed over-dimensioned power supply to the controlled system. Output ratio limitation is usually set to 100 %. For heating and cooling, output ratio limitation can be programmed to between 0 % and 100 %.
• Control parameters for heating and cooling are separately adjustable. There can be no overlap of heating and cooling.
• In "Ready for operation" and "Alarm" operating status the controller outputs are set to zero.
  

Settings ranges and control precision:

• Feedback: Xp: 0…100% Tv: 0…200sec Tn: 0…999sec
• Switching cycle time: 1…240sec
• Output ratio limitation: 0…100%
• Setpoint limit: -40…400°C
• Control precision in steady state (without sensors): ± 0.5 K
• Resolution in the steady control state (without sensors): ± 0.1 K

Control functions (example for temperature control solution):

• Heating, cooling, alarm, pump (on/off/empty)
• Watch-dog: Permanent monitoring of correct software process
• Temperature warning
• All data are storage is power failure-proof.
• Filling/float switch
• Cooling and switch-off
• Fill time monitoring
• Restart lockout
• Do not heat dead zone
• Switching cycle times
• System lock
• Tool emptying
• Leak stop (direction of rotation of pump - phase switch - is carried out via relay).
• Display of error messages